Set of 4, 15in CSA alloys and 195/50's all round. ****WARNING these are FRONT WHEEL DRIVE OFFSET****. I can supply the wheel spacers and possibly the longer wheel studs to fit mags to 1200 ute or similar. To view mags on my ute search photo album for "my 1200 tilly" its a white 1200 ute. $350ono

Hey mate,
Just wondering how much tread is left on the tyres? R u positive the will fit on a 1200 ute with the spacers and studs and would it be possible to get them sent to qld?
thanks

Hay dude, they came off my 1200 ute. I can supply you with the 20mm front spacers and longer wheel studs. For the rear you can use standard wheel studs as the rear spacers are only 5mm which I will also supply. As for tread the rears are good re-treads and the front are ok Nankangs. They are a bit worn on the edges from hard cornering. If you dont want the tyres I can just send you the rims which might make shipping cheaper and I will knock a few bucks off. I live in Townsville North Queensland and shipping should not be a problem, It may cost you a few bucks.

Hey Mate, r the front rims the same width as the back, if not do they track the same i.e r they in linie or do the front stick out wider then the back

On my ute the front tyres sat a little wider than the rear. You could fix this by fitting wider spacers on the rear. Up to you. You sure you want to run spacers anyway, I think its illigal in QLD. look into it befor you make your final decision dude.

spacers are illegal in most states they increase risk of snapping studs. but isnt a rim 3" bigger than standard illegal to.

hey mate,
its all good. just wondering if u could get a price for shipping to gatton, near toowoomba.
thanks m8

Bump

Sorry about the delay, moving house sucks, especially moving into a smaller one with all my excess junk. I will take a rim to work with me and get a price on shipping ASAP.

hey mate
no worrys