Here is some pictures of my home made intake for A14 megasquirt turbo setup.

looks good!

if you ever want to make more i need one for my lpg turbo project, no injector bosses.

what throttlebody are you using?

i used a ga16 throttle body 60mm flows good for us with room to grow.

Very nice work.
Did you smooth the inside of where the runner meet the plenium? when (Or if) I ever do something like this, I'd turn up some funnels to make a more progreesive entry from the plenium to the runners.

VERY nice work. Well thought out & engineered.

Was this the same intake you ran 12's with?

Damn nice work... Good on ya! Cant wait for next summer so we can see an 11 out of the a series :)

Throttle body is from bmw 500 series e28 6-cylinder.

Yes I did smooth the inside of where the runner meet the plenium

This is not the same intake that I have been runiing 12.1, this should be much better.

Some pictures of my new engine:

WOAH. this thing is going to be wicked sick.
Could have gotten an i/c that had inlet and outlet on the same side to reduce piping... just a thought though.
what else has been done to the engine. its going to be awsome anyhow

WOW, thats full on, what size turbo are we talkin, very impressive work, please tell us more

is this primarily a drag set-up? i would not anticipate that there will be any boost below 4-4500 rpm. if the internals are done then i don't think there will be too much trouble with an 11sec pass.... maybe squeeze a 10 with some extreme conditions! that is mad!!

edit; don't forget to turn your oil gallary imput on the turbo straight up and down!