HI GUYS
I am running a14 with 2mm shim head
std cam 36 dcd weber (boxed)
ihi rf5 turbo @ 0.3 bar
What kW and torque should she be running
at with this setup ??

Dyno result today = 60 kW atw 5900 rpm
110 Nm

That would sound about right to me, perhaps a little low, (only about 10kw) but about right if its faily std setup. ie no headwork, std cam, no intercooler etc.

I want to up the boost to about 1 bar
i have lifted head by 2mm will the motor take that much (std dish pistons) ??

hey mate im running the same turbo on my a12 i have it injected aswell and running 15.5 psi with a14 head i got about 80kwatw so that should give you an idea. this was before i upgraded the exhaust its now a 2.5 inch mandrel bent system, in the piccy you can notice the massive dip in the the graph this was from the exhuast being to small it was only a normal 2 inch exhaust. the graph is now a smooth ride all the way up to 80

i also had a a12 blow throu carby setup with the same turbo which got 69kwatw but it only reved to 4grand

looks pretty good for 5 psi,
if the fuel is there, take it back to the dyno and boost it up to 10-12psi.

just make sure it dosn't ping or lean out on boost

shimming the head is bad for rocker geometry and creates another join to seal
use a15 head bigger decomp chamber
dazza