hey all ive stared doin some work on my little ute, its full striped ive stared shaving the engine bay. i cut the floor out as it was falling out from rust and about to replace it. ive welded my gate in and put my new roll pan on it as well as stated shaving it should have side caps and tub full shaved tomorrow.

will be rolling on a set of 17's lowed with custom built coil overs in the front and reset leafs with air bags to drop it all the way in the back. as far as the rear diff goes im goin to replace it with a shortened r31 diff with a LSD. getting some billet hubs machined up to make the stub patten the same for all 4 corners. heres some picks tell me wat ya think so far, theres a photo shop in there as well.

when i got it with pair of old commo 17's sittin next to it

thanks, Dan

Attach file:

---

  ute side.jpg (39.95 KB)


  rain rail gone.jpg (29.16 KB)


  08082010_002_ mini truck ass draging.jpg (68.65 KB)


  P9040002.JPG (192.08 KB)

fantastic work

good work ,what air bags are going in it ?

i thought about bagging my ute but i decided not too cos i didnt know what front struts i could use that i could buy airbags for ,but i have since found out that S13 silvia struts can be adapted to suit a 1200 so they might be the way to go if you are going air bags all round instead of just the back

nar mate doin it so it will be 100% legal so no bags in the front i live in qld so yer they dont like air bags in cars but ur alowed load carrying bags with just a mod plate so i will have (load carying air bags) with extremly low springs and will pump the bag up to legal high to drop u just let the air out

http://www.youtube.com/watch?v=iurn49TMWbo like this

where abouts in QLD are you Dan?

Looking good :P.

bout 30 mins south of hervey bay

hi all have done a little bit more just the top cappin and the shaved the other gate latch hole, now just got to do my plate box, fill in the hinge holes and put my exhaurst gaps in to the roll pan. then the gates ready for a good old boggin and sanding.

thanks, Dan

Attach file:

---

  top capping.JPG (179.38 KB)


  full gate.JPG (159.10 KB)

any one happen to own a old hilux tub they wont to cut the light brackets out of for me? woulld be a huge help if some can help me out