I have four units for sale, these are a plenum inlet manifold and a log style turbo manifold. All items are made from quality mild steel and all welds are personally inspected by me.

These are suited to a draw through turbo setup but will also work for blow through and (with additional work i.e injector bosses) fuel injection.

Price is currently around $750 including delivery to Australia. Let it be known that delivery is $125.00 to Australia, this equates to $312.50 per manifold which I think is a bloody good price.

Material: mild steel, detailed specs available.
Flange: oval port or round port
Fabrication: SMAW
Finish: Interprime 198 & Interlac 649 gloss.
Turbo compatibility: T2 series.
Delivery Time: 3 weeks (+1 week to get my #OOPS# together!)
Suit Vehicle: B110, B120, VB110, KB110
Price: $750 delivered to Aus

Additional Notes: 10% discount to the gentlemen who purchased some weather shields, worry not i will have them finished soon, sorry for the ridiculous delay, it is worth it i promise.

Pictures:

Attach file:

---

  image.jpg (91.36 KB)


  image.jpg (142.16 KB)


  image.jpg (151.40 KB)

Hot damn, great.price! A series guys it's a basic log style manifold but will work well still, for 99% of users will suit rather than equal length style exhaust manifold.

Nice low position for easier dump pipe too Chris. Go png!

Can vouch for Chris (clyons8) we have been chatting while he has been developing this. Great guy to deal with...

I will post pics when I receive my set in a detailed build/development thread

Thanks BeeJJ, yeah Mik, that was the idea for the manifold keep the dump pipe nice and smooth. I also intended to have an alternate inlet in the bottom of the plenum to reduce the amount of plumbing and have the turbo feed directly into the underside of the plenum.

Here are some more photos:

Attach file:

---

  Turbo 1.jpg (197.46 KB)


  Turbo 2.jpg (167.69 KB)


  Turbo 3.jpg (192.14 KB)

Yes inlet in the middle is better to distribute air. I spoke to Baz at datsport about this for ages

This exhaust manifold is basically the simplest, I can do several other types which vary in cost depending on complexity and material.

Thats awesome Chris, wish I still had an A series.
Can you do that for other makes? My Hillman could do with a few more horsepower.

have you tried one on the cherry yet??

Can certainly try Andy but will need critical dimensions, Troy, would you like me to make one for a cherry? Send me a message if you like.

Can also fabricate a dump pipe to suit. Will have pics of another turbo manifold type shortly.