Does anyone know what seats would be an "easy" swap for a 1200? Any info is appreciated. I know someone mentioned late model t-bird seats, but I've been unable to locate any.

sigma seats are not bad, the rear mounts have to be cut off and a bit of L-angle welded on but they are good and cheap

I have also seen late model Toyota FXGT seats modified to suit, (few minor welds)

someone has also mentioned Mazda MX6 seat?? Not sure how well they go in though..

i have prelude seats in mine at the mo, again a couple welds and its all gravy.

i was thinking maybe triumph seats but heard there made of poor british matrial

i got mine done up! and repaded. its a option

Mazda RX7 Series 2 Seats are good.

They have the same "runner tracks" width. I think the 1200 runners fit straight onto the RX7 seats. Only RX7-S2 ,that's all I know about.

I'm thinking of getting the Mazda Miata (MX5) seats with speakers in the headrest for my 1200.

Chris

A guy I know had his ute seats redone with extra padding it turned his crappy seats into very comfortable units

dude my seats are that comfortable serious, i paid 280 to get em done they have etra paddin sides and back, red leather, and and embrioded grey velour with red trim they are that good the guys who did em did the best job

they were just a little private shack place, proving that ya shouldnt judge a book buy its cover

you can have a look at em there in my photo album



(p.s Ade check ya messages! )

Cool. Thanks for the info guys! At least now I know what to look for the next time I go to the wreckers. Thanks again.

Roughneck