Hi Guys i was wondering if u could help me out here,I would like to know what suspension upgrade i can do on my ute for a heavier motor it seems to be to low in the front the tires are scraping,any suggestions will be very welcome.

Increasing your spring height is a good thing, and if there is a heavier engine use 300 pound springs

Thanks Could i use any Make coils?

With the nickname of A-14, i am confused about what this heavier engine is, & what chassis it is in. I'm guessing that it's a B120 ute,

I think it is called a B140 ute there by u guys its its a 1998 1400 bakkie UTE but im doing a conversion that seems to upset the 1200 club members so i can realy say

toyota swap
traitor!

So not only is this brand X engine heavier, but since the Datsun blokes don't favour it, then it must also be inferior.
If this brand X engine is so heavy that you need stiffer springs to hold it up, are you sure that this is a good swap? There are a lot of good engines out there [even brand X ones, but i won't repeat that in public] that are also light enough to be "1200 friendly" so i hope that you have chosen wisely.

Never mind. Good luck with it.

Im Sorry Guys if u know y im doing it you will understand ,Nissan/Datsun Never made a motor like this one and i wish they did otherwise i wouldnt be forced to do it.but my a-14 is going to give a VW beatle a new life and it should become a quarter mile monster.