Sorry if I didn't spell it right but I hope people know what I mean. My CA18DET has no spigot bearing, it never has.
Are they ment to have one??
Could me not having one ruin bearings in my gearbox???

Where the bearing should be it just seems to taper down, how much would this bearing cost???

Thanks for any help.

Cheers
Damo


PS I feel stupid in asking this question as the answer is probably obvious

I love nissan.co.za..that's 34 RAND.. AU$7.77.. Less than eight bucks.

22-01 32202-B9500 BUSHING - CRANKSHAFT HITACHI SELECT USE NONE NONE R 34.70

Nissan.co.za Picture of the part

Cheers,
Chris

They should have a little brass spigot bush in the back of the crank!! Can but new from nissan. I bought mine form a local auto one for around $15
If you dont have one this is probably why your gearbox has failed I had a rebuilt stumpy box in mine for a week and it failed the problem ended up being the front input shaft they used in the rebuild was slightly shorter and not sitting in the spigot bush propery changing into 4th overtaking a truck at 120 and instant cog soup.
Good luck