Hi

I need to put a hydrolic clutch on my 1200.

Just wanting to know if any one knows what master cylinder to use?

If u got pics of your setup they would be great.


Thanks in Advanced

Mitch

Hey mate.... it isnt a easy or hard to setup hydrolic clutch up, more of a headache

But there are various ways you can you a Urvan internal setup, or inbay setup.

I used a inbay setup with a new 180b clutch clyinder. I put mine next to my brake masters because the wall there is extra stong and doesnt flex and then i could use my stock clutch. I cut a hole there (which is quite tight measure twice ) then i had to mod the linkage so it was alot shorter, then lined up straight with my pedal and drilled the hole.

Other options are the under dash (Urvan internal) and using a s1/s2 bluey pedal mounted left of ur old pedal with the clutch master setup.

I have pics of my setup i will post on 1200.com and put a link no here for ya

Link to pics:
http://datsun1200.com/modules/myalbum/photo.php?lid=7742
http://datsun1200.com/modules/myalbum/photo.php?lid=7741

P.s but if you are using a Ca18det or another motor in ur 1200 this may require a much different setup!!... the CA owners would know.

For CA or SR setup: -

Grab yourself a clutch pedal assembly from either a R31 skyline or similar year pintara.

Make sure you get the little bracket that seperates the clutch pedal / spring ass'y from the firewall. It'll just be spot-welded on.

Then it's just a case of drilling the appropriate holes in your 1200's firewall.
You will need to brace the pedal / spring assembly as the firewall isn't rigid enough to support it (don't forget that little bracket), but this should just be a matter of bending up a bit of 5mm strip & drilling a couple of holes to affix to your steering column.