im after a stroker kit for a ca18 turbo has anybody done this, if so what does the capacity work out to and how much would be a ball park figure?

Woody here is a link for the guys who sell a lot of ca18 parts in japan Greenline motorsport
Tomei in japan do this kit I looked at doing it but was far too $$ for little gain in capacity it would end up being 1950cc and cost was close to $7000 for crank rods and pistons to suit. Plus all your other bits & pieces . A normal ca18 bored 1mm would give 1850cc and can make ample power 400hp+ is not hard with the right parts. I will be selling my old setup with 1mm over forgies race preped rods ect will be going cheap as they are second hand and I no longer need them. They made over 200rwkw reliably
Cheers Andrew

JUN, Tomei, Greddy (trust)...

all high priced jap stuff but well woth the cash. if its going in a 1200, traction will be more of an issue that with a stocker