As title says, im after the lower apron or panel under the rear bumper on a sedan, just need the curved part.

If anyone has a sedan I can cut up gimme a pm or call 0432 909 790.

Cheers
Sean

BUMP anyone wrecking a sedan?

might be able to give you a hand on that one... send me a pic highlighting what you want, and i'll see if its any good on my wreck...

That would be great if you could mate,

I need this piece under the bumper, just the outer curved part from seam to seam, If you could cut about 20mm wider than the seam and up under the bumper would be fantastic.

See how you go!

bump

I've got one.. but you'd need to wait for me to drive to adelaide for a Nationals. I'm not even slightly keen to organise packing or post.

Good Luck all the same.

Thats cool mate, I hate organising postage for people too. I cant wait very long as the car has to be in primer next week to go for cage etc. pm if you have a change of heart, I dont think it would meet aussie post specs either, too long.

bump

Hey Sean what kind of cage are you going? Chrome molly or mild steel? And 6 point?

Cheers

Im 99.9% sure its mild steel (the bloke was going on about it being cold drawn steel as per cams specs), its being tig welded, six point and comes with certificates etc.

I was going half cage but Ive been waiting that long may as well go hell for leather and do it properly. Only thing is I dont want it to go through my dash pad so it will have to be attached to the A pillar and then straight down to the floor.

I was going to get side intrusion bars but they can be added later on.