Just wondering so i can eliminate some of the trial and error, what size jets have people run on their blow through 32/36 carbs. i understand that i will also need to drill out the needle/seat hole to allow greater flow too. if a few people with experience in this field could shed some light on what size jets they have it would be much appreciated...

Thanks in advance...

use the stock jet on the small side and go i think it was 240 on the other,well thats what i used and it was a good air fuel ratio. it also depends on how much boost is going to be used

so 240 main and stock secondary? does that mean it has a 2.4mm hole? i'll only be running about 10psi tops. 7psi for the moment.

240 for the secondary and yes it should be. well i used the 240 on 14 psi so maybe take a little off maybe 220 230

yeh ok. that at least takes alot of guess work out thanks mate.

ill try a 210 secondary for 7psi and leave primary stock. adjust from there.

cheers