hey guys just tring to put on et pulsar wheels on my 1000 ute. i need to space them outwards about 20 mm but i have to then get longer studs. is 20mm too much each side. ive seen most spacers are 3-5mm

I run 5 or 10mm spacers on the front of my 1000 with Watanabes with plenty of thread left i think. only one way to find out!

20mm seems excessive, I was hesitant about spacing by 8mm as the wheel studs looked too short, with 20mm missing off them I really do think it will be too much without replacing the studs with longer ones. also you might have to get the spacers custom made as i've never seen ones off the shelf that big.

why are you using the pulsar rims? there are plenty of other options in the datsun stud pattern that dont need spacing out.

bolt on spacers if they that large..
pulsar rims, eww

20mm sounds like alot.

Could you make your own spacers out of Mild Steel or is that a stupid question.

Stainless would be good no?

these are the 1st ones I found, shouldnt be hard to get something like this.

http://cgi.ebay.com.au/Wheel-Billet-Adapter-Plates-Skylines-180sx-S13-SILVIA_W0QQitemZ260242049218QQihZ016QQcategoryZ42614QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Matt, either get proper bolt on spacers which will run you in excess of $100 pair or you can go knock some pintara wheel studs out at u-pullit. You get an extra 7-10mm there, but not really safe putting that much strain on wheel studs 8mm spacer is max I would put behind a wheel.

I'd just get different wheels.