Hi guys,

I'm installing a Twin DCOE 40s at my A14 stock,the problem after installing it, i cant rev it more than 4-5k rpm (the engine loss power) :( .

What is the main problem?And how to solve this?

Advice me please

Thanks in advance.

Common causes:
* partially plugged fuel filter
* bad/worn valve springs
* Incorrect engine timing
* partially blocked air filters

What jets & Chokes are you running? badly jetted 40's = no power.

yer im not sure if you have them jetted to your engine but that probs a good start, trial and error pretty much is you best opotion cheers

thanks guys,

ddgonzal:i've checked the valve springs and the engine timing..it was ok ,and i ran the carbies w/out airfilters..plugged fuel filter maybe one of the factor..thanks

Rezlo:i'm not sure about the jetting bcoz this carbies is taken out from alfetta 1.6l engine (i've never jetted it)..so probably the jetting is the mainly cause?how to calculate the best jetting for this stock a14?

Gylezy: i've trial and error and playing with the mixture screw and the distributor but the same thing is still happening especially when i try to run the engine in 1st gear..

it is totally ok when idling but worst when i want to drive it..

cheers.

hey
my twin 40 webers are form an alfetta aswell
i have them on a worked a15, flat top pistons, chunky cam and so on....
maybe take the car to your local carb shop and see what they recommend ? =}
cheers