Browsing this Thread:
1 Anonymous Users
|
|
Getting it together |
|
Home away from home  
Joined:
2008/6/1 9:55
From Oberon NSW {Bathurst}
Group:
Registered Users
|
Hey guys, I am just getting all the bits I will need for my A12 rebuild and I have just a few questions.
1) When fitting an oval port head ex A15 do I use the A15 push rods or the A12's?
2) Are the bores A12/A15 the same?
3) Do I use A12 piston and rods or A15 with the A15 head?
4) When fitting flat top pistons will I have valve clearence issues?
Your advise is appreciated as always.
Posted on: 2009/6/2 0:23
|
|
|
|
|
Re: Getting it together |
|
Home away from home 
Joined:
2008/6/17 9:44
From pooraka,,adelaide
Group:
Registered Users
|
i think u will need to use the a12 ones wen i ran my a15 with an a12 head i used my a12 pushrods
Posted on: 2009/6/2 2:05
|
|
_________________
620 ute -sr20det full irs
vanette-a15 turb
260c- daily
1000 4dr- a15
1000 4dr- project to be sr20
garage 910
|
|
|
Re: Getting it together |
|
|
Guest_
|
bores are different sizes for the a12 to a15 piston, check the wiki
Posted on: 2009/6/2 3:02
|
|
|
|
|
Re: Getting it together |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
For A12, keep all bottom end stuff the same including pushrods. Just change the cylinder head.
Posted on: 2009/6/2 3:21
|
|
|
|
|
Re: Getting it together |
|
Home away from home Joined:
2008/6/1 9:55
From Oberon NSW {Bathurst}
Group:
Registered Users
|
Thanks guys
Posted on: 2009/6/2 13:01
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
