hi all, i need some of the following:

link to pics of the ones i need

all need to be 16mm

SF.1190
SF.1102
SF.1105
SF.1209

some will be on pg one of that link.

I have been quoted $29 for the t peices from most places locally and $19 for the 90 deg bends. Its a joke!

Its so i can fit the heater back in the 1200 asap cause its cold!

If any one can help out it owuld be great

Bunnings maybe? I've been finding so much good stuff there from clips to little alloy arms that could be used for sidedraught carbs.

Or you could scrounge the wreckers for a handful of fittings, takes time though.

Did you try the boating supplys yet?
But if you want to stay within yr budget Id recommend Coburg trash and treasure at the drive in on Sundays, if not the fittings at least youll find ppl stingier than you are ;)
I bought my fully sick custom valve tap from there for 2 bucks!

boating supply store was same price.

im not being stingy but when its $90 for all the ones i want its a bit silly.
$35 for a t peice is stupid.
last ones i got were $7 each. shop closed down now though as was when i was running on petrol.

did you try this : hsupercheap

that is what I used

i've always gone to pirtek for stuff like that, what are you trying to achieve? just t-pieces in the water hoses?

thats what i need but they must be cheaper than this. also i need 5/8 not 1/2 due to lpg convertor water piping.

ebay? or try the market, that will be cheapest if they have em, theres a place in baysy that sells cheap tools called FJ's but even they arnt cheap on these fittings.... think you have to bite the bullet

any one seen or tried these?

if there are any stockists in melbourne?

plumming supplies