Browsing this Thread:
1 Anonymous Users
|
|
Another Tacho wiring thread.... |
|
Just can't stay away  
Joined:
2010/4/29 0:51
From Central QLD Coast
Group:
Registered Users
|
I have had a look at the threads from the past about wiring in a tacho, but they all seem to be directed at the Datsun brand tacho and not any of the newer ones. I have the installation instructions but I am still a little confused because I'm sure my loom does not have a 'RPM Signal Wire' in it.
I have some photos of the instructions and it clearly states that the 'Green' wire (obviously just for this tacho?) goes to the RPM signal wire. I'm curious as to where this wire should be wired to. I would have thought to the + side of the 12V coil I have for the electric ignition, however it clearly states that this 'Green' wire should also NOT be touched to a positive source.
So does it get wired to the -ive terminal on the coil?
Posted on: 2010/8/21 5:41
|
|
|
|
|
Re: Another Tacho wiring thread.... |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
'RPM Signal Wire' is the Coil Negative terminal. Some newer fuel injected cars have a special wire for it, especially ones without a distributor.
Posted on: 2010/8/21 6:09
|
|
|
|
|
Re: Another Tacho wiring thread.... |
|
Just can't stay away Joined:
2010/4/29 0:51
From Central QLD Coast
Group:
Registered Users
|
You DD are a champion!! Thanks heaps mate 
Posted on: 2010/8/21 6:43
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
photo(5).JPG (35.31 KB)
Transfer
