well from my research there are only 2 cluth pressure plate heights, 41 or 51mm. Is this correct?

as im using the short throw out bearing carrier, i need the taller pressure plate, 51mm correct too?

also are there any samller clutch disk size than 200mm, i hope not. and i dont want to step up to the 225mm as my flywheel is already set for the smaller plate.

thanks.

I'll go measure mine up mik, I've got 3 here from memory I even might be able to help with fly if needed

oh also the bearing needs to be pushed onand off the carrier, is it just a simple puller to get it off or a specialist tool?

im planning to change it all with the help of another member after xmas.... stuff paying mechanic $350 in labour not including parts and stuff.....

nah stuff changing fly too.... thats a pita.

Easy! Not hard mik! If box out and clutch off it's only 5/6 bolts to take off fly! Stress less

There are three size of L-series clutch disk/pressure plate

180mm - L13 & L14
200mm - L16, some L18
225mm - L20B, some L18

i doubt it would be the 180mm one... wish i or piggy could remember, i just remeber it was the smaller 1, as l13 and 14 arent sold in aus, im guessing its the 200mm one.

I've got 3 200mm flys here mik, and the 4 speed I've got has bearing and carrier is bout 50mm

3 200mm flys or 3 200mm clutch disks?

what tyoe of clutches? any good ones for fanging lol.

ill have to get thrust bearings too. cheers nik.

ive got flys, pressure plate no good, and clutch plate almost stuffed to1
i have an almost new set here but its bolted to my l16 with the stumpy 30 hanging o0ff motor