Hi all,
well new member, actually signed in on behalf of my boyfriend i'll get him to fill you in on his little project at the moment a bit later. I've had a bit of a look around and
looks like a great site i'm sure he'll love it when he gets to see it after work.

But we are (well i'm trying to help but know nothing about it all) looking for the settings for the main bolts, big end bearings and for the head i think.
If anyone here could help that would be great.

Hope this helps..it's for an A12..but should be the same.

Dattoman.

Extracted from Datsun 1200 Repair Guide (Peter Russek, 1972
England)

Mains 36.2 - 38.3 lb.ft
Big Ends (connecting rod big end cap) 23.9 - 28.2 lb.ft
Crankshaft Pulley 108.5 - 115.7 lb.ft
Flywheel 47.0 54.2 lb.ft
Cylinder head 32.5 - 36.2 lb.ft
Camshaft/Crankshaft sprockets 32.5 - 36.2 lb.ft
Camshaft locator plate (2 bolts) 2.9 - 3.6 lb.ft
Rocker Shaft Bolts 14.5 - 18.1 lb.ft
Crankcase Bolts 2.9 4.3 lb.ft

Sorry,but some of the A14 torques are very different. Sorry I didn't respond sooner but I couldn't find
either of my Manuals.
Main Caps.....36 to 43 Ftlbs
Rod cap bolts 23 to 27 Ftlbs
Crankshaft pully 109 to 145 Ftlbs
Flywheel bolts... 54 to 61 Ftlbs
Cylinder head.....51 to 54 Ftlbs
Camshaft sprocket 29 to 36 Ftlbs
Camshaft locator 4 to 6 Ftlbs
Rockershaft bolts 14 to 18 Ftlbs
crankcase/pan blts 3 to 4.5 Ftlbs
All Data from Clymer's Manaul Pub.Date 1978
covering "71"thru"78" 1200 and B210
sorry for the mix up
C-Ya steve
P S thanks Dattodude,I needed to find those books!
C-Ya