Hi guys I need to know whether or not the rod for the inside door release goes on the inside off the window regulator.Oh guys I have worked it out it goes underneath the door skin,is that correct?

Attach file:

---

  8361.jpg (56.67 KB)

I Can't remember how mine was although i put different regs in.i hope your putting this back together after being painted

Yes mate after its painted.I have that many bolts,screws and nuts in bags I have to keep on looking at them so I don't forget.And that's with them labelled.I also have another question,with the bailey channel is it installed in 2 sections as I thought that it would have the front half done the vertical part on the 1/4 window side and on the vertical side at the back off the door so the window can be put in place and then bolt the 1/4 window in place so the window is in its slot then glue the top part off the door.So basically the bailey channel will be in 2 parts.

I know lots of people that label bolts and that really seems to make life hard.to be honest when I did mine I only labelled my regs and threw every other single bolt in the bin.then when it come time to put back together I bolted it all up with brand new stainless bolts,washers and nuts.the regs only really go 1 way so wasnt really hard.not sure about the bailey channel as I deleted my quater window

This is what I mean.

Attach file:

---

  door.jpg (132.55 KB)

Looking at that yes it would be in 2 peices

i didnt do mine in 2 pieces, but would fit way better with that corner cut like you said

That's how the corners should be cut notching it out at 45degrees

Quote:

It goes in between the door and the door skin.

Yeah worked it out after I posted,cheers anyway.