Yeah I have some marking out die. THe blown motor is already together( sill awaiting me to get off my ass and bolt the blower to it) But if it succumbs to "terminal failure" this other motor could well see some blower action,

Hey a14force, good to see that its all done. is this for the s/charged motor? or will you be running na to start off with?

in any event, get some bluing grease and match port all inlets/outlets to really get your moneys worth.

a dye grinder is the male equivalent of a vibrator...grind baby grind...lol...

I didnt get much done really, just hardness and pressure tested bronze guides bigger ex valves seats recut just a smidgeon of edges rounded off. It cost me $150 but that was mates rates. Its nothing really flash but I just condemnd 5 or 6 heads that were rooted and its very rare for me to spend big monet . I usually sneak by doing everything on the cheap. So its nice to know I wont have to touch it for ages.

Hey a14force, wat did u get done? and if you dont mind me asking how much did it cost. I'm about to get some headwork done too, so I m just getting a rough idea of prices. Cheers

Plz send us some pictures and some flowspecs if you have.......

between you geetin a good head and 1200rc getting blown, im feeling a bit flat now (my batterys dead)

picked up my gx head from the head guys today, gee it looks good. I had to post this thread so I could post that title!

Oh yeah , I like the other kind too.