Cheapest and easiest would be , chop down the front springs with an oxy whilst still in car, then heat up rears with said oxy until they match the ride height at front.

Repco sell king springs for about $120 or $98 with trade discount. While your springs are out replace the strut inserts while your at it because you dont want to have to do it all again a month down the track when you realise your are stuffed. Rears dont worry if there still in servicable condition as you can change them at any time.

If your nothside of brisbane Jack Beedhams exhaust arnet bad for all your need.

Front springs $120
Rears reset to your height $115
Monroe inserts front $120
Monroe Shocks rear $80
And all shackle rubbers. I got all nothelene ones for $40. Replace these as there usually frigged or will be after pulling it all apart.

And if you want lowering blocks $70 1inch all the way to 3inch.

where is the best place to get king springs from? do you need a particular model to suit?

thanks for that, yeh , i wanna do it properly so it's not bumpy as, but yeh cheers

Properly
Kings spring lows front
Reset rears flat and blocks if you want a little lower

Cheap/dodgy
Cut fronts
Reverse leaves or massive blocks on stock springs

what's the easiest/cheapest method of lowering the 1200 ute?