heya Topgear.. have you made any more exhaust manifolds or planning too?

TopGear where is that coupe located ADL?

Anyone know of a way to make BB turbo without the carbon
seal to stop burning oil with some kind of flap setup and
bypass?

I

aww cumon topgear, i aswell as many im sure would love to hear more on the turbo side of things. Much inspiration. I think all of us who read these threads think, dammit IM going to make one

Hi cheater.... Yea its still in the pipeline...

Ive made an executive decison that I need to finish my first car first!
Ive done some major mods to the cars suspension etc, but I dont want to say to much till its near completion...

I still want to finish the std A12 J-pipe project though. I like the challenge of making something out of nothing, I learnt a lot from my first car so know how to make the second turbo set-up more streetable...

Quote:

Just looking At these pics you can see how big the hotbox flange is on the A14 manifold. If your were to affix say a 20mm plate, then bolt a turbo to that plate. The A14's have a way larger flange than the A12 ones.

HUMUNGOUSLY LARGE bump right here.
what happened topgear?

OctaneR

you still got some turbo manifolds?

Is there cell or landline number? e-mail addy?

i reckon thats a good size for a low boost turbo a12 running draw through. I have found that when the turbo wheels stops spinning eg, big turbo on little motor at idle that fuel likes to puddle in the compressor housing causing a rich stumble on quick throttle opening after idling. Im following this project with much interest!