are any of you getting radius scrub problems with R31 struts? or are you running RCA's to help the problem?

ra40 celica hub brings it in 10mm but still not enough..

but they carry a different disc centre bore and most likely different disc mounting pattern

cheers pigdog
i have heard 260z hubs are shorter??

and you will find nothing that you want looking at datsuns and nissans
try toyotas as most of them have the same bearings

every datsun/nissan hub that i have seen that will go onto stanza struts is the same offset wheel wise, its only disc offset that has changed

but toyotas, coronas and such, use the same size wheel bearings....cant remember if they had more or less offset though

looks like im going to the wreckers tomorrow with a tape measure...lol

Well all dato's up to Z31, save the 1200 and early 120y use the same wheel bearing so you'll have to do some research, have fun!

they may even be 240k struts??
they have already been shortened and has a decent sized disc...
just the wheels stick out too far and i don't want to put in shorter lca"s as i want as much neg camber as i can get.....
surely there is a hub that will fit that brings the offset in???

Tappet, Late model 1200 ute or 120y (74 or 76+??) lower arms may do the trick, the stanza/sunny balljoint will bolt to the lower arm which should be the same length as a 1200 one.

You will have heaps of positive camber though, on my partners 1200 with stanza struts + stanza lower arms I have used 13" suzuki fwd rims which are super close to the strut and clear the guard no problems, stanza struts are way too much trouble to fit in a 1200 properly, and the brakes arent even that good.

is there any hubs can i use to shorten the track width on my stanza struts???
it sticks out past the guards and i don't want to buy new rims..
also the 120y hub won't fit because the stub axle has a larger diameter???