yer all my mod's where under 500 bucks go and talk to mark nixon so you know wat you need

i think the mad dat bolt in kit is around 800 to 900 bucks but then you need to get an auto trans tunnle and weld it in or do a few test fit and cut yours out where is needed

x zorst:
ive got a 3inch form turbo to the back and a supper cat muffler and its not loud at all 3'' is the only way to go bud more flow the better

do you drive your ute around townsville if so are you the dude with the jetpoilt sticker on the tail gate???????????

I had 6 modification codes done for $300.
Engine, Brakes, Diff, Seats, Fuel Tank & Tailshaft... From memory.

$400 is more like the going rate though.

I have heard that in QLD it's around $150 an item. So if you have swaped motor, gearbox and diff that would be $450. I think.

depends where u are.. in adelaide itd around 2grand, nsw is i think 900 800 mark

any one got a price of getting the car mod plated even rough i just need to know if its gonna be like $100 or like $1500

Quote:

Hahahaha...... Nothing like a bit of optimism.

The wife asked "how long?" when I started my project..... I replied "oh only around 6 weeks"

3 years later I finally finished .

They also say a project car is never finished

Have fun.

so u think im getting ripped. i dont think i could do it my self im 17 and a apprentice carpenter i dont wanna try, ill take the motor out my self ( a12 and box) but thats probly as far as ill go i dont have a enclosed place eather ill probly rebuild the diff with with a good lsd with my dad because he has lots of experience with that, hes about to start his torana SLR5000 but were struggling to find a place that will sell a LS7 if any one knows were he could get one of them that would be good but... its not eazy to find them there a 427 small block from the new corvette ( 505 hp !!!) we have found them on the net but i think he wants to go through i proper shop

Quote:
I was "going" to have my sunny at this years datnats, but it was only today that it got back from Micks. At least it drives, turns, stops and does all that stuff now. Now I just have to get it painted, put all my new interior in and do this, that and the other, and it will be ready for rego.
At least by the time it is finished insurance will be a bit cheaper cause i will be older.

Quote:

It's like I keep saying, "I'll have the CA up and running next month for sure!"

hey mate wat is the work shop gonna do ?
are they making the engine mounts ? coz if your buying a half cut and all the gear from maddat . and they are charging $1500 to $2000 just to put the motor in your getting ripped off coz putting the motor in, is a 2 hour job wit the maddat mounts. the wiring and intercooler is the hard part .
whos doing the gear box tunnel ?
whos doing the brake booster ?
tail sharft ?