was thinking the same about the crossmember how it sits the engine that far forward...but you can always just redo the engine mount slots to get it in a good position

but thats just coz they are made so that an engine can slot straight in and not have to worry about sump clearance and what not
if you were to make your own you would take more time to get it to sit lower and further back

Oh found it! looks pretty good and straight. plenty of new bits and a ca18 allmost ready to go. tiptop's!

Yeah deposit made.Its there the guy is on the road goin to end it when he gets to a pc. Some parts are already farmed out to other members as part payment for there help.

Did you buy it? just went for a look what you lot were talking about and couldent fined it?

mmm my collection is building up again,Oh Sedans are sweet.

It's been re-listed heaps of times, from memory it started at about $6000 buy it now, its still being listed.

For your info Cross Member was made by a guy Who was one of the first to do the CA and SR conversion Kev Rowley from QLD a well known and well respected guy and all around good bloke.

Take a good look at that crossmember, doesn't look right to me the mounting points are too far forward and the engine mounts will only be sitting on half their diameter( will sit hanging over the edge of the crossmember plates)

make him a offer andy

That's good to know matey, Thanks.