Browsing this Thread:
1 Anonymous Users
|
|
Re: WANTED: A-series Extractors / headers |
|
Not too shy to talk  
Joined:
2008/3/7 12:05
From Gold Coast
Group:
Registered Users
|
pm sent.
Posted on: 2009/8/5 13:44
|
|
|
|
|
Re: WANTED: A-series Extractors / headers |
|
Home away from home  Joined:
2008/4/23 13:03
From Sydney
Group:
Registered Users
|
PM'd
Posted on: 2009/8/5 10:52
|
|
|
|
|
WANTED: A-series Extractors / headers |
|
|
Just popping in
Joined:
2009/5/31 12:32
Group:
Registered Users
|
WANTED ITEM:
Extractors / headers for an A14 motor (with a round-port head).. though i don't suppose it maters..
CONDITION:
Any..
REASON FOR wanting:
I have an Austin A3) in which I am putting an A14. IT is a real tight squeeze down low and at the back near the box (though with oodles of room up high near the ports). THus I am ideally after an old pre-loved set that I can play with and perhaps 'persuade' to fit with the help of a whole lot of heat and a big bar... ANd ideally, ideally, I'd like a set that ran as close to the engine as possible... (but anything is better than nothing...)
PRICE AND PRICE CONDITIONS:
cheap cheap, and any condition (as long as they dont have holes!) as I may well end up killing them in the process
LOCATION:
I am on the Central Coast (NSW), so can get them from Sydney, Newcastle or even further (perhaps via post) if need be.
Posted on: 2009/8/5 1:37
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
