ok man thanx

if your angle arent to critical just buy two 90 degree bends, some straight pipe and some flange plates to suit and im sure i can help ya out, give me a call and we'll sort it out for ya

oh ok yes i understand it a little now iv heard about it but didnt think it was esential i guess i'll c how it goes cause i wouldnt mind going injection down the track so i'll c how it goes now and do it if needed otherwise wait till i do my next set of mods
but thanx for that i forgot all about doing that

Here is when I was asking ages ago; maybe do some searching.

Stock dizz applied turbo

Yeah famous in a nerdy way, with biologists and scientists. I asked if he got any hot chicks chasing him and he said all he got were old grannies with coke-bottle glasses. "well you gotta start somewhere man" I said.

He also had something to do with the Pygmy seahorse, tiny little seahorse....like the humming bird of the avian family (birds). He's always been into that sort of gear, freeing whale sharks from drifting nets etc etc. Cool dude I tell ya.

Back to Datsuns;

It is recommended (for performance) that you lock the centrifugal weights of the dizzy, well that's what I was advised to do when I bought my kit. I cannot speak from experience though whether it matters a whole lot but if you think about it long enough it kinda starts to make sense (advance etc).

Just ahead and see how it boogies and then consider locking the dizzy weights.

did he get famous cause of it??

yes im runnin that elec one i got off mal

Yeah people are always finding new species there. Seahorses, birds, my mate has found a new species of frog about 8 months ago. Pretty exciting stuff.

Have you sorted out your dizzy for the car as well??

ps chris u hear about that huge rat found in png in the sorrounding of the volcanoe or something? it was talked about on the 7pm project the other night they had a video of it

sweet thanx chris yes i wasnt sure if it was a dump pipe or not so i didnt say it was iv already got the flanges just need to run the pipe and weld it together im just finding out who is around to do it so wen manifold is made i get it going prettymuch strait away

This bloke may be of some help.

Mike - boostdute

Advert for boostd ute

If the angles aren't too complicated and you know your dimensions etc then I'd ask Dan to give you a hand both are exceedingly good welders.