Townie, I'm about to sell my 450x300x76 intercooler. It's
never been used (only trial fitted). Have also got two smaller coolers if your looking for something unobtrusive.
PM me if your interested and I could email some pics to you.

more then likely gunna fit a bigger radiator, as i have a ca18det. I might just talk to an engineer and ask whats legal to cut out.

Another option if you need to leave the rad support intact is the 270x300x76 core size (450mm overall lenght) coolers avaliable on ebay for $100. These fit in the spot in front of the factory radiator and need only two spots were the outlets are trimmed out. Factory radiator can still fit if staying a series, grille needs small triming too but fits nice. This all means car can go back to stock if needed and should be easy to engineer. Cooler should be big enough for a mild street setup, rated at 400hp. Cheers

wow thanks for all the replies.

Done mine a bit differently, but probally alot more work.

Check out my build thread

got cooler from ebay, 2.5 inch inlet/outlet,cut and rewelded in/out
made it fit alot better
check my project thred

Attach file:

---

  100_1369.JPG (167.54 KB)

600 x 300 x 75. - Was a hybrib cooler, just mounted it up side down.

Attach file:

---

  240.jpg (54.13 KB)

To fit a 450 x 300 x 76mm neatly behind the grille
you will defintely need to do some trimming of the
radiator support panel. Most I have seen have also
required some minor trimming of the front apron panel
as well.

I am trying to avoid the trimming of the front apron panel
and have been looking for a slightly thinner cooler.


He Tommoz where did you get your cooler from and how
much was it. Also does it have 3inch of 2.5 inlet/outlets??

http://datsun1200.com/modules/newbb/viewtopic.php?topic_id=42547&forum=1&post_id=282127#forumpost282127

Search and you will find...