i did it check out my build thread make sure you rust proof it as much as you can and if you do your tray lips aswell be sure to reinforce it with some metal. the torque of the motor will snap the weld.

franks project

Have fun reading through it tho

Quote:

Yeah shirty i was thinking about this....but wat about where i can't get behind???

Make sure you get in from behind and rust proof it properly... when you weld the front it will blast everything off the back and will rust like the titanic

Sounds good cturbosa, yeah i'm looking at doing the same thing with the fuel flap and the reversed Spout.....

sorry champ i seen the date next to your name and though was the post date of the thred haha, im in south australia. it wont be an issue to do the work i just wanna see some before to ensure i like it, if i havent herd any thing ill just go a head and cut all mine off and weld them up im also welding up my petrol flap and turning the spout around n fill from the inside the tray

cturbosa - Where are you located??? wat old thread??

wanna dig this old thred up as im chasing pics of people that have removed guttering as im considering removing the ones on mine this time around painting it

yea boiiii that's what i'm talking about ddgonzal that looks hot!!!

armiee you know how the girls say, no beauty without pain lol, so your saying i should make sure i wear a waterproof hoodie when driving lol

Mradtree23 - will do- yeah i was thinking that i might be lucky enough to be able to use some magnets to hold it together while i put a few tak welds on...

Thinking i might need to start a build thread...

Check my build thread, there are some good pics of my rain rails getting removed... As for the hook ridge once off it will need to be joined somehow again as it is two separate panel inner and outer! Good luck

My mate removed the rain sills on his old Gemini, he said yeah it was great for shows and such, but when it rained and he'd open the door he cop a drenching of water haha