that's cool good work

I don't have the time either. The 304 steel for the flanges was recommended by the cutter as better suited to the application. And you did bag the quality of my steel but now you've edited the post.

All I'm saying is that I bought GX Head new in box a H75 and a round port head all NOS and borrowed a H89 NOS so I could get the most accurate drawings. I scanned and measured all the heads and drew them up and ran trial batches so there were many costs there and lots of time spent on them.

I made about $3.00 to $4.00 per item when I sold them so I made nothing and had hundreds and hundreds of dollars spent on getting the heads. If I had my time again I wouldn't have bothered as it wasn't rewarding (apart from knowing that I made cheap flanges for alot of people).

If you can get good prices through your mate and you can bring the prices down then swing me $25.00 for each hour and I'll draw whatever you want. As for the Datsun side emblems and vents yes I am making a profit (bigger profit for the side vents as I had to get those drawn up) keep in mind the previous price offered on here by another member was $150.00 per set (was asking $200 at the start) for the cowl vents without screws and excluding postage. I was sending them out with screws and postage for $89.50 aus-wide.

Nothing comes easy these days, I give out free parts regularly and free advice where I can offer, with drawings I simply cannot do it.

I never bagged your quality just the grade of steel used . I've asked a few times for the drawings but have not badgered you.! When I have some time maybe I will make some, but as for now I don't have time. This is not the place for this stuff, ill just leave u alone and won't speak a word about it to you again. Ta nick

Yeah well that says it all. Do it yourself, I knew I was doing the right thing by not giving them out I mean listen to you, you sound like a real good bloke now don't you.

How are you helping? You keep hounding me for my drawings like I'm your best mate. I don't give drawings out like they're worth nothing, I worked alot to get those flanges right and even did a trial batch to make sure they were ok.

You are the one who has been hounding me for the drawings, I haven't done anything to tick you off until you hounded me so much that I said something.

And now you bag me about the quality of the items I have made? Thanks a lot Nick real nice of you.

good luck casey

pm replied to chris

Not selling, do not want to sell and will not sell. You've bugged me enough and this is enough.

Get it through your #OOPS#ing skull.

I sourced a brand new GX head, brand new Oval Port Heads and Brand New Round port heads to draw those flanges up so they cost time, lots of money and effort.

Do it yourself and stop being a slack cunt, you keep telling me how you can get it done all easy so do it. I've had enough mate and I never speak to people like this but you pushed and now you have my honest answer.

Or just go and flog terry's drawings like the other slacker did without even asking to mass produce.

go datsun

I did a lot of work to get those drawings done and I'm not going to go handing out the drawing like they're worth nothing. There is alot more to it than just slapping a drawing together. Sure some people give their drawings out, but I don't unless I know you well.

Casey I've sent you a PM, I have pieces left over (alloy, MS, SS) and I''m willing to sell now (short on cash) so get back to me and we'll go from there.

bump