There are a couple of pics in my photo album. Seriously they weren't that hard to fit, but the job was probably made easier by the fact that the flares I got were a specific design for a 1200. Unfortunately 120fly isn't making them anymore.

Seeing as though you've fitted them DAT141, could you possibly shed some light on the issue, regarding design, fitment, etc including pics possibly? I'm looking into it aswell for my 4dr.

My rear doors open just fine. The rear flares are cut in half so the front half stays on the door when I open it.

I dont think Them bolt on arches work on 4 door sedans unless you dont want your back doors to work.

Then they should rather remove their website, as this is pathetic.

i have called, left messages, emailed, had friends call from the states, nothing.. no answer from classic datsun :(

The ClassicDatsun ones would be the answer, let's see if they reply on the emails?

The ZG ones will also work, but think there will be some fiberglass work involved.

ClassisDatsun is the answer, if they could only answer their emails.

I have a 4 door sedan and I have been looking into this tirelessly, http://www.classicdatsun.com/index.html have the flares listed on their site, but dont answer emails or calls :(

I found that B-Project Sells them out of japan for lots of $$$, http://shop.ebay.com/?_from=R40&_trks ... _sacat=See-All-Categories

I think I am going to go with ZG Flares for the 240z, I found some small ones that are fairly cheap and I wouldn't cringe cutting up to fit. http://cgi.ebay.com/ebaymotors/ZG-fla ... uckQ5fPartsQ5fAccessories




zg flares on a 510



here is a link with the measurements of the ZG flares: http://cid-380ce9227e6edd65.skydrive. ... esid=380CE9227E6EDD65!397

I have been told that these can bend a bit, and I am "ok" with fiberglass to I can cut/patch them as I need..

I am also looking for suitable flares for my 1200 2d sedan......Quote: