replied.cheers

pm sent

i have king bearings in stock,depending on sizes.cam bearings, if fitted properly,dont need honing(they come finished size).thanks chris for feedback.cheers

Quote:

bige (post #4) is you best one stop shop supplier. His prices are good and he has supplied many people. Send him a PM and he'll sort you out.

He supplied my last rebuild kit and I was very happy with the service.

Nissan recommends we do not replace the cam bearings, unless they are damaged. Replacement requires line honing.

hi do you know were i could get king bearings for an a12 in australia

any online stores??

thanks!

i use king bearings in all race engine and others i build,they are excellent .there is a special tool which you use to r&r cam bearings,local reconditioner could do it for you ,cheers .have some bearings for dato a series come in my kits,

i was looking at the king bearings look nice just dunno if they have em for datsuns.

just wandering how hard its to replace the camshaft bearings do i need a special tool to slide in the bearings in thr block?

thanks!

lot o companies do.

Clevite Tri Metal

hi i am in the process of builiding my a12 engine i am most likely getting acl pistons but i wanted cooper lead bearings for the mains and the conrods

so the acl ones arnt cooper lead only thier race series is and i dont think they have it for a datsun!

so does any one no what company supplies cooper lead bearings also how much they would cost??

1 more thing does anyone know how much is to get a 4cyl rebored next piston size up??

Thanks!