Yes, 4-bolt Hitachi and S.U. pattern is the same as two bolt. It would probably bolt up sufficiently tight.

GX ovals are 36 mm high - above the mounting bolts
A14 ports are 34 mm high - below the bolts

Quote:

Unforunately to original picture showing them side by side is to big so just cut these smaller images out. Don't know if you can see the difference?

The holes for the 4 bolt carbs seem to line up also checked with 1 3/4 su's 4 bolt, they line up as well.

Thanks

img width is OK

You need the img URL (ends with .jpg) -- not the photo page URL.

That's it. Just remove the image width stuff.

[img]http://datsun1200.com/modules/myalbum/photo.php?lid=23468[/img]

EDIT. whoops gimme a second.

Here is the actual image link, you can tell by the 'jpg' file reference: http://datsun1200.com/uploads/photos/23468.jpg

Then when you link it in you either remove the "width=300"[img width=300]http://datsun1200.com/uploads/photos/23468.jpg[/img]

so your link should look like this [img](insert link here)[/img]

a14t



gx

A14T uses standard A14 head and the twin-sidedraught manifold has standard A14 oval ports -- smaller than A12GX ports.

Trying to upload photos, always have trouble with this.

Um I don't know about the a12t but bought th gx manifold to line up with the gx head, but it didn't come with carbs. I thought it might be ok to mount the 4 bolt carbs just using 2 bolts.

Thanks

Oh okay, I don't know much about the A14T stuff. You wouldn't happen to have a picture of both manifolds side by side would you?

I guess what you need is an A12T manifold.

I don't think the a14t manifold wil line up properly with the gx head. The inlet ports look to be a bit higher up.

Thanks