Shocks mount like pic in this link dd here

Does the Aussie-assembled B210 with BW68 diff use the same spring plate as Japan-built ones?

Shoulder bolt diameter is unknown.

But the fasteners at the end are:
08911-64010 NUT-HEX M10 B210 Sedan, Coupe
08915-14010 WASHER-LOCK B210 Sedan, Coupe

The shaft could be larger.

Attach file:

---

  B210_Sedan_Spring_Plate.jpg (112.55 KB)

And for a b210 or b310? Seeing IM,using b210 bw68 diff

1200
Quote:
However they use a special shoulder bolt. The shaft part might be a larger diameter.

Just checked superpro catalogue. None listed for stanza rear but the same part for both 1200 and 120y b310 gazelle skyline etc

One has 12mm bolt hole,other is 16mm.

I need check mine as says 120y is 16mm. Thought mine were 12?

In trying. Its a $200 gamble IM not willing to take dd. The measure mental I have for a 1200 sedan are 30mm wide 30mm high and 12mm hole for bolt. That's the bush sizes in my Monroe gas.

Stanza shocks are 35 wide 35 high with 15mm hole.

IM wondering.If I could trim bush width or replace bush with 1200 one? b210 and b310 list same lower bush as a10 wagon but not sure on sedan

Let us know what you find out.

After market has replaceable bushes. Just trying to see if can use stanza shocks in 1200 sedan rear.

The bottom bush on Sedan shocks is press-fitted during manufacturer and so is not sold seperately.

All other 1200s have removable bottom bushings.

What about bottom bushes that connect the shock to the rear leaf as springs?