A professional alignment is supposed to include inspection for such problems in the first place.

I have not heard if they are repairable. Only replaceable.

hi Guys

I went to the alignment place and they found the issue on the Cross ROD bar ends they have a free play on them, Are those replaceable or repairable or do i need to find a good one ? Damn do i have to push the all set back down to repair it ?

thanks
regards
sumith

Attach file:

---

  Resized Cross ROD.jpg (53.68 KB)

Yes, camber is non-adjustable when using the factory parts. But your camber is out-of-spec (greater than the maximum). Nissan recommends finding out which part is bent and replacing it.

The camber is most likely not the cause of the shaking.

Hi DD

According to the Wiki 1200 Camber in non Adjustable is it ? This is 1978 Hb310

http://datsun1200.com/modules/mediawiki/index.php?title=Camber


will i be abbe to adjust my camber problem ? if not what parts should be replaced to make the proper camber ?

thanks
regards
sumith

Hi DD

thanks. i talked to the particular technician who did this, he said will balance the tires and re fix them.
and also major issue here in the alignment they select a manufacturer (nissan) and particular year (In this it says N14 sunny -1994-1995) in the machine it does according to the car manufacturer.

thanks
regards
sumith

Attach file:

---

  Bill Header.jpg (37.56 KB)

Quote:Yes, I see a problem:
Camber (front left): -0.80
Camber (front right): +3.20

That's a huge difference left-to-right.

It becomes worse, probably because the rear tires are more unbalanced than the front tires. Have them all re-balanced. Shops are often not correctly balancing the tires.

Hi DD

I interchanged the front and rear tyres then it became verse
i checked each and every tyre for bent or crucked but none of them had such an issue , so what strange problem could this have,what else to be checked further ?
It was running perfectly earlier i could reach 100 KMPH without any wobble or shaking earlier,

then suddenly it came. so i replaced the tie rod ends because they were not good too.

Could this be These Tyre Combination changes

Earlier

Rear-165X13 8PR
Front-155X12 6PR

Now

Rear -165X13 8PR
Front-155X80X13 6PR

if i interchanged this combination it became verse


Look at my Wheel Alignment Report do you see any issue there ?

thanks
regards
sumith

Attach file:

---

  Wheel Aliignment_new.jpg (43.97 KB)

fixed

Hi DD

thanks i will check ,it seems link in your post doesn't work please check it is it a web page or picture

thanks
regards
sumith