Browsing this Thread:
1 Anonymous Users
|
|
A14 Comp Rods, or ??? |
|
|
Just popping in
Joined:
2003/4/25 1:41
From Vancouver, BC, Canada
Group:
Registered Users
|
Anybody know anything about Nissan Factory Comp. rods? Number on rod side is 25-0 H85-1 and marks on big are 31-0. Also, at wrist pin end there are three holes - one on underside and two at top. Botton one is countersunk. Has a single side oil hole inn nub on top of big end. Rod is approx. 121mm long. Rob bolt is 8mm with marking "R" at top end.
Also, i have another rod with same dimensions but different marks and about 1/4 thicker shaft. Marks on side are 1-0 900051-1 and on big end are 53-0. Also, rod bolts are black with marking "T" at top end. Nuts have their own integral one piece washer and are slightly longer than stock ones. Length is again approx. 121mm.
I am going to weigh them tommorrow, but anybody got any ideas?
Posted on: 2004/4/20 5:24
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
