send it to lags, had a closer look, going to foul on extractors, just, my extractors hang pretty low but not that low

thanks beatie pm sent. can give it to you lags if doesnt work for me.

I have a pre anit-deiseling A12 carby on my A15 on the 1000. Goes well! Still revvs clean and crisp up to 6200! Weber is going on as soon as Holley get around to delivering my jets! Been waiting nearly a month!

so if unfam doesn't want that coz he can't use it... can i? i have an a14 in a 1000. will it fit around the standard a10 exhaust manifold?

also is an a12 carb ok to use on the a14?

I have a vannette manifold... They sit lower so their almost guarenteed to hit your extracters! I cut out all the water gallery out to try to make it clear... but it still fouled.

Yours at the cost of postage!

only after inlet manifold, have extractors and crby already

I have an inlet and exhaust maifold also a rebuilt carby

I want $150 ono for the lot

Cheers
Dan

wanted as above, needed incase change to webber 32/36 in near future.
located in melbounre but willing to paypostage from anywhere in aus.