Just finished fitting mine from Knox today. It was all good, a bit tight up under the heater and around the kick plates. just go easy small cuts at a time and you'll be fine sorry I don't have a photo to send.

Alrighty thank you. = ]

i bought one a couple weeks ago. very happy with it. moulds better if u use a decent amount of underlay felt. cutting the holes is easy.

I got one for my 1200 Coupe, So I guess the front bit would be the same.

Got a Plush in Charcoal grey and very happy with it. Would not recomend super plush as was hard to hold normal plush carpet under the sill plates. Used a few screws to pull it into place. I glued mine with a flooring glue, which you apply to both surfaces, but it does not go off. So you can get the carpet out if required.

The edge near the seat rails is trimmed with edging, the floor plate/mat on the drivers side also looks good. Does not come with any holes cut so you need to cut them.

Hope this helps.

Nope but i have used TruFit they were real good got the Top knotch water proof one for 1200 coupe Auto tunnel delivered for $125

Hey has anyone bought their pre-moulded carpets. Just got a couple of questions. I have a Datsun 1200 ute to fit.

-What are they like?
-Good quality?
-Fit well?

Any help is appreciated.