This is the first run before the roll over, only damage caused was cosmetic pushed in front guard, roof just popped out again. I'm going to make a set of front struts for it as it was bottoming out over the jumps and going hard into corners, so I'm going to cut up a set of Toyota Prado struts and adapt them onto the bottom of the datto strut. Possibly use a standard Hilux coil and hopefully that won't be too stiff.

Attach file:

---

  tilly.jpg (75.54 KB)

seek help mick...

I encourage you all the time ed.... to take it like a man, on the chin in the rear however its served up

great stuff mate, love the fact there's nothing but encouragement!

Top work mate! Is there any post race day photos of the rig?
I love the fact it 'was all good' and they had a ball! Go kiddies....The Datsun will get a name for itself with them results :)

Nice work from the kids. Let em kill it. Will take a beating for years

Here's a bit of an update on the little ute. The kids raced their very first event this weekend, eldest boy (12yrs) raced first and put her on it's lid in the very first race ( I think he was a little over anxious). First of all he thought he was in trouble but he soon worked out it was OK when I was laughing and praising him for going hard while we're both sitting upside down looking at each other, that's my boy. lol. Had a great weekend drove on the truck ready for next meeting except maybe a couple of hits with a rubber hammer on the little panel damage. Boys did exceptionally well, Youngest (10yrs) got a 1st place in the mud drags and eldest got the 2nd place and the youngest got 4th in the circuit mud sprints. The L20B actually goes pretty good considering all it has is a side draught webber on it and it runs rough in the mid range circuit. Works great with the auto, pulls strong in 2nd with the 14" tractor tyres on, the kids are keen as now. I told my boys it's been rolled now so drive it hard you got nothing to loose.

Attach file:

---

  Tilly rollover.jpg (76.02 KB)


  Tilly rollover 2.jpg (82.40 KB)


  Tilly rollover 3.jpg (70.54 KB)


  Tilly rollover 4.jpg (82.04 KB)

thanks for that, 733a sound like the go to me.

$120 posted not bad including cam. but call wade too, if you have some spare cams similar price for a regrind.

i got a second hand wade 733a came. i like it, not lumpy and pulls to 6k no issues, mice seat of the pants improvement through midrange for sure.

Hey thanks for the offer mate I would have been very keen but the cam is too big the rules state must be no lumpy camshafts. Thanks again Shane.