Just trying to go as light and clean as possible with my tube frame chop top and smooth rotot engine.
Disregard the 3 heater thing it was just a joke. All you need is one of these suckers especially when Im going to run perspex motorbike half dome screens.
refer "chop top 1000" for an example.



found out another bit of info for those who bag EWP

"A "traditional" pump sucks up a remarkable amount of power and is chronically inefficient since it is permanently engaged and must work at all speed ranges, from idle to "red line". At maximum revs a modern 2 litre engine is wasting almost 8 bhp just driving the water pump. Imagine you could turn the pump on and off as needed or better still adapt its speed and power consumption to suit the conditions. This is where Davies Craig comes into the equation: their Electric Water Pump is designed and manufactured in Australia and simply replaces your old belt driven device. An electronic controller not only monitors the temperature of the coolant and switches the pump on and off but also adjusts its speed to match demand. And more importantly, the Electric Water Pump drains only 80 watts, or about 0.1 bhp. This means that the average car will inevitably be much more efficient to run. In a typical example supplied by Davies Craig, fuel consumption for a 2.7 Ltr. Engine drops from 9.0 to 8.55 Ltr/100k. a fuel saving of about 5 percent."