Browsing this Thread:
1 Anonymous Users
|
|
Re: dizzy's |
|
Home away from home  
Joined:
2000/5/26 7:46
From Good Old Knockfull, Tennessee, USA
Group:
Registered Users
|
With the A12 and A14 heads, you can mill off up to .250 inch safely but then you are in trouble with push rod lengths. Shorter push rods or spacers the same thickness of the mill off of the
head to put under the rocker towers are necessary. I have milled .250 inch off an A12 head and put it on an A14 motor. That came out to 215 # or 11.75:1 compression ratio. A high
compression motor makes for a lot of more cheap fun but you have to compensate with higher octane fuel. Water injection helps as does adding one pint of diesel to ten gallons of gasoline
helps. Read back into these messages and you will find a lot of information from a lot of other people that may help you. Hope this helps you and your mate with your experiments. Have a lot
of fun for me too.
Mareo
Posted on: 2000/8/19 10:05
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
