Hey everyone,
I finally got my ass into gear and went to get my CA conversion mod plated, but I was knocked back for a few things (that I didn't know had to be done)
-Copper fuel lines I can't have (must be metal, WTF I know 2 guys who got their conversions approved with mod plating)
- Gearbox mount, I have a piece of angle steel about 10cm away from each chassis rail and I've welded on pieces to meet up with the original mount points as well as 2 bolts through the floor. I can't have that as it must be bolted to the chassis rails??? Also the bolts through the floow needs to have a 50x110 plates welded to the floor and get the bolts to go through that.

- Retractable seatbelts, I still have the standard fixed length ones

He also hit me up for a few other roadworthy things like side veiw mirrors and my wipers came loose so when you turned them on they would move a bit then get stick and the rod would move in the wiper arm.



Has anyone else had any similar probs with getting complienced or do I just have a prick of a mod plater?!?!?!

Thanks for anyones feedback

Damo