The Dato is back in action

Cheers Jempson for the rods, they didnt fit found out the rods on there were modified, more than 12cm of extra thred!

I just got the rod machined and tapped for very cheep at the gear makers at Kirrawee except the cost of the die nut I had to get cause the gear makers didnt have one the right size but I got it now for next time it happens!

Is there any way to measure the caster at home or should i just get it adjusted by a wheel alignment place?

I put the ajusting nuts approxamitly where they were on the old rod by measuring the distance between the seccond hole and the nut on each rod, I will test drive it soon should be pretty close.