Browsing this Thread:
1 Anonymous Users
|
|
Re: A15 performance work question |
|
Quite a regular  
Joined:
2003/9/23 9:52
From Windsor NSW
Group:
Registered Users
|
Yes, the reason i wanted to use the A14 pistons is for compression rather than just being cheap and shaving the fark out of the head.
Sorry my mistake, yes the A14 and A15 block is the same height.
I have done some more research on this site and the go is 60 thou not 40thou.
I have been looking at something else as well which may be worth doing if i'm going to do this as well is bore it out and put bigger pistons.
This is what i have found:
pin to crown piston dia. pin dia.
RB20E 32.5mm 78mm 21mm
VG20E 30.5mm 78mm 21mm
A14 32.5 mm 76mm 19mm
A15 30mm 76mm 19mm
I know 20mm is the biggest someone has bored out the pin hole in the conrod, is 1mm more just a little too much to ask for, i think it may become too fragile and will make it not reliable and may brake.
Posted on: 2004/11/14 6:56
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
