Browsing this Thread:
1 Anonymous Users
|
|
Re: 120Y rota coversion |
|
Home away from home  
Joined:
2004/3/3 9:32
From WA
Group:
Registered Users
|
RX3 mounts are front mounts - unless it's a 10A with side mounts.
you can bolt any mount to the intermediate plate of the engine - as mazda do.
you'll need to cut the risers off the crossmember and MAKE mounts if you plan to use side mounts.
otherwise the RX3 crossmember will need a section removed and BOLT it thru your front chassis (don't forget to take the same amount out of the timing cover mount).
OR
put the LH mount on the RHside of the car, and the RH mount on the LHside of the car (so they point on a 45deg angle with the boltholes vertical) and bolt them to the SIDE of the chassis.
this is by far the easiest option.
Posted on: 2005/1/24 8:09
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
