Browsing this Thread:
1 Anonymous Users
|
|
Re: H72 head |
|
Not too shy to talk  
Joined:
2003/6/30 6:09
From Sydney, Australia
Group:
Registered Users
|
As for an a14 head onto an a12 it is quite easy from what i understand. The oil gallery to the head doesn't line up with that from the block but this can be fixed by drilling a hole, maybe around 6mm, not too sure, in to the head to pick up the oil gallery in the block and in the head. It would only need to be like 5mm deep. I would suggest putting a head gasket in place on the head and marking the oil gallery hole in the gasket onto the head. Then simply drill the hole in the head just enough for the full diameter of the drill bit to start cutting. Then the head should bolt straight on without any dramas!
Posted on: 2004/12/30 1:25
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
