Browsing this Thread:
1 Anonymous Users
|
|
Re: Can I make my own camber plates? |
|
Home away from home  
Joined:
2005/2/23 6:14
From gold coast QLD australia
Group:
Registered Users
|
Hi
I made my own camber plates for Matts 120Y sedan race car,i just copied from the picture found on this site.
Used a 10mm thick plate of aluminium and a 8mm plate of steel 3 new studs and 4 bolts.
Tools needed... A jig saw a drill a file and a ruler and vernier calipers and a 8mm and a 10mm tap(cost of material was $60 AUS).I did not use a bearing at the top as it is used on the track only,sorry i did not keep any measurements.
Hope this helps GREG.
Posted on: 2005/10/4 9:08
|
|
_________________
GO RACING,GO HARD OR GO HOME!!
SLY OLD FOX..................
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
