Quote:

Phunkdoctaspok & I discussed this in the stanza brake upgrade thread. It depends if your local DOT has fallen into line with the national code yet. In WA it is "not more than 25mm" you may be ok where you are.

Page 39/LS72:

"Where non-original axle or suspension cross-member components are fitted, the offset of the wheel in relation to the axle or hub assembly used, must not be increased by more than 12.5mm each side of the vehicle based on the specifications of the axle components used. If an axle assembly is shortened then the track width limit is taken as the axle manufacturers original track dimension, less the amount the assembly has been narrowed, plus 25mm;