Browsing this Thread:
1 Anonymous Users
|
|
Re: valve timing? |
|
Quite a regular  
Joined:
2006/4/4 7:05
From Mira Loma Ca. USA
Group:
Registered Users
|
First, I guess, would be to ask why you feel the need? Most "rookie" mech.s fail to put the dizzy back in the correct position. get engine to T.D.C., then pull your cap and see
where the rotor is pointing, adjust accordingly. Also, check the valve adj.for too tight. If you still feel the cam timing is not right, I think it best to pull the motor out, as the gaskets WILL leak!
Posted on: 2006/5/9 17:47
|
_________________
1965 Datsun Fairlady 1500-A14 powered! 5 Speed All GX parts with twin Dellorto 40's 10:1 compression. 1976 B210 stock smogger with "dogleg" 5 speed and a ton of suspension work (coilovers, camber plates, etc. etc. etc.) 
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
